Programmer STK500 AVR ISP ( Burn Program for AVR, Upload Bootloader Compatible for Arduino) kr 199 med USB A-B kabel, du trenger gjerne og 10pin til 6pin adapter for kobling videre til kort, nb: Programmer works with Atmel Studio and DOES NOT WORK for Arduino development environment.
It can not supply power for the target MCU so you should supply power for the target independently.
Driver for PL2303 chip is not compatible with win10 now.
This is an AVK ISP compatible for the STK500. Before using it, you need to install USB to serial chip PL2303 driver for your operating system.
Note: There is no power for the ICSP-10P interface to protect the programmer itself, so you should supply power for AVR MCU / for the board before upload program.
Features:
– Support for IDE versions: AVR Studio 4, 4.19, 5, 6.x, 7.x
– Support chip:
AT89S51, AT89S52.
ATmega48, ATmega48P, ATmega8, ATmega8A, ATmega88, ATmega88P, ATmega8515, ATmega8535, ATmega16, ATmega162, ATmeg164P, ATmega165, ATmega165P, ATmega168, ATmega168P, ATmega169, ATmega169P, ATmega32, ATmega324, ATmega324P, ATmega325, ATmega325P, ATmega3250, ATmega3250P, Atmega328P, ATmega329, ATmega329P, ATmega3290, ATmega3290P, ATmega64, ATmega640, ATmega644P, ATmega645, ATmega6450, ATmega649, ATmega6490, ATmega128, ATmega1280, ATmega1281, ATmega2560, ATmega2561.
ATtiny12, ATtiny13, ATtiny15, ATtiny22, ATtiny2313, ATtiny24, ATtiny25, ATtiny26, ATtiny44, ATtiny45, ATtiny461, ATtiny84, ATtiny85, ATtiny861.
AT90S1200, AT90S2313, AT90S/LS2323, AT90S/LS2343, AT90S/LS2333, AT90S4414, AT90S/LS4433, AT90S/LS4434, AT90S8515, AT90S/LS8535.
– Interface: Standard ICSP-10P
– USB to serial TTL chip: PL2303
– Application: upload booloader for Arduino. (ATmega328P, ATmega168P, ATmega8A, ATmega2560), burn program for the AVR microcontroller.
NOTE1:
Programmer works with Atmel Studio and DOES NOT WORK for Arduino development environment:
Select «Atmel stk500 development board» as programmer. («AVR ISP» or «AVRISP mkII» will not work), When using programmer for Arduino development environment.
When Using AVRDude select «-c stk500v2» or «-c stk500» for protocol. Do not specify a baud rate, or alternatively specify
«-b 115200».
NOTE2:
It can not supply power for the target MCU so you should supply power for the target independently.
Photos
